loading
reading
writing
saving
searching
Emotiva BasX A500 Amplifier - $400 (Rolesville)
QR Code Link to This Post
Power Output (ALL channels driven):
• 95 watts RMS per channel; 20 Hz – 20 kHz; THD < 0.1%; into 8 Ohms
• 130 watts RMS per channel; 1 kHz; THD < 1%; into 4 Ohms
Power Output (two channels driven):
• 120 watts RMS per channel; into 8 Ohms
• 175 watts RMS per channel; into 4 Ohms
Power Bandwidth (at rated power; 4 Ohm - 8 Ohm load): 20 Hz to 20 kHz (+ / – 0.02 dB)
Broad Band Frequency Response: 10 Hz to 80 kHz +0/-1.8 dB
THD + noise: < 0.02% (A-weighted); ref rated power
Signal to Noise Ratio (8 Ohm load):
> 116 dB; ref rated power; (A-weighted)
Minimum Recommended Load Impedance (per channel): 4 Ohms (equals one 4 Ohm load or two paralleled 8 Ohm loads)
Damping Factor (8 Ohm load): > 500
Input Sensitivity (for rated power; 8 Ohm load): 1.2 V
Gain: 29 dB
Input Impedance: 27 kOhms
Input And Output Connections
Input Connections: Unbalanced (RCA); one each per channel
Speaker Output Connections: Audiophile grade 5-way binding posts
Trigger:
• Trigger Input: 5 – 12 V (AC or DC); <10 mA input current required.
• Trigger Output: 12 VDC; can drive any load up to 120 mA
Power Requirements
115 VAC or 230 VAC @ 50 / 60 Hz (automatically detected)
Front Panel Controls and Indicators
• Standby: push button
• Status LEDs: one per channel; blue
• Status LEDs change to red to indicate a fault condition
• Standby LED: amber
Rear Panel Controls
AC Power switch: rocker switch (switches AC main power)
Status LEDs switch: disables front panel Status LEDs
Protection
The BasX A5 is protected against excessive operating temperature, shorted speaker connections, ground faults, and other common fault conditions.
Mechanical
Dimensions:
• 17” wide x 4” high x 15-1/2” deep (unboxed, not including connectors)
• 21-1/2” wide x 8” high x 21” deep (boxed)
Weight:
• 26.5 lbs (unboxed)