Parting out a 1988 Chevrolet S10 (Benson)

Parting out a 1988 Chevrolet S10 1 thumbnail

QR Code Link to This Post

I am parting out a 1988 Chevrolet S10 long bed. All parts are you remove (bring your own tools/etc), as-is where-is. I am within 2 miles of Benson Elementary School (2040 Hwy 50 N) here in Benson, NC 27504.

Non running 2.5L 4 cylinder engine mated to an untested and unknown manual transmission. The driver fender has a small amount of rust at the bottom (see pictures). The passenger fender, hood, and passenger door are all straight and solid. The bed is straight as well, with some small holes that were drilled (possible work truck) but no noticeable rust.

Part prices are as follows (The front and rear bumpers are both sold, as is the driver's door.):
Fenders - $60 each $100 for the pair
Hood - $120
Grille (already removed, center section only) - $100
Front Bumper filler - $60
Passenger door - $125
Bed w/o tailgate - $300
Rear Axle (dash rpo codes gt4 which is 3.73 ratio, no g80) - $250
Tailgate - $100
Manual Transmission - $250
Rims - $150 (full matching set of steels)

Other parts priced on interest. $50 minimums.

post id: 7887937742

posted: 2025-10-11 16:54

updated: 2026-02-09 08:03

♥ best of ^[?]

reading

writing

saving

searching

refresh the page.

Parting out a 1988 Chevrolet S10 - auto parts - by owner - vehicle...

I am parting out a 1988 Chevrolet S10 long bed. All parts are you remove (bring your own tools/etc), as-is where-is. I am within 2 miles of Benson Elementary School (2040 Hwy 50 N) here in Benson,...